I have a 566 mega wide baler and am having troubles with the end wraps falling off the bale. i found an owners manual on line and the photo that is shown does not match what i have as far as mechanical adjustment. there are 2 rods with pins, 1 each side that have adjustment holes. is this where i set the beginning end distance. the photo from manual shows a knob adjustment which i cannot find. see attached.
Yes, I changed the settings on monitor from 3" all the way up to 7" and no difference. The OEM manual stated to set the mechanical guide first, then adjust the monitor setting to desired edge distance. Problem is I cant find an adjustment knob like shown unless I am looking in the wrong place.
Holy Crap, I am a dummy. After studying your attachments I see what I need. My baler has the upper option shown rather than the lower which is what was shown in manual. Thanks for your help TxJim.