I have a 2005 317 Skid Steer that I am going to install an aftermarket cab heater in and wanted to know where the best place to tie into the cooling system would be for the 2 heater hoses that will need to feed the heater core? I have added these heaters to boats in the past and have simply backed out a couple of plugs in the engine (1 by the manifold and 1 by the water pump), put on hose fittings and ran from there but I am not as familiar with skid steers so any advice is welcome? Could I simply "T" off if the exisiting hoses going to the radiator (1 above and 1 below)?

Thanks in advance.