Help me understand so I purchase the correct valve. To my understanding there are two different "types" of valves for the application.
It makes more sense to me to STOP the flow, rather than slow the flow, this is where my confusion lies currently.
Since the 3PH was installed, I've been dialing up the stop. This works fine, but that's a chore IMHO.
If I have the plow blade on front, I leave the tilt hoses disconnected.
If I'm going to install a valve, I'm thinking (Keep It Simple Stupid) I'd like to relocate it to somewhere more convenient, so I don't have to reach into the abyss.
A thought was to have the valve vertical to the running board in plain sight. Maybe just forward the pedals. Or in the area of the deck adjustment knob.
I'd consider putting it inboard of the toolbox even.
My reasoning for relocating, it just makes more sense to me.
Help me out here fellas. The valve, it's been on my bucket list, and I haven't wanted to chew on the expense.
It's time to get it done.
Share me some creativity so I don't choke on the cost of the valve. LOL
You point me to the valve to stop the flow, and whatever else is needed to put it where it's wanted, it's getting ordered and DONE with.
The Deere AM134625 valve won't mount the way I want.
Auxillary Hydraulics has one that I believe would.
Any other suggestions?