single acting hydraulic cylinders
Results 1 to 2 of 2
Like Tree1Likes
  • 1 Post By ttazzman

Thread: single acting hydraulic cylinders

  1. Top | #1

    Join Date
    Jan 2019
    Last Online
    05-16-2019 @ 01:16 PM
    Location
    Missouri
    Posts
    1
    Thanks
    1
    Thanked 0 Times in 0 Posts

    single acting hydraulic cylinders

    I have a MW BF10 wheel rake that has single acting hydraulic cylinders on the raise and lower for the wheels. My problem is they are slow to go down I have looked for orifices and there are none in the hyd plumbing. I use it on a 4020. I have tried it on a 4240 and a 4430 and neither will allow the wheels to go down. the cylinders have springs attached to them to help them lower. I have taken the cylinders loose and moved them up down by hand and they work fine. I am at a loss as to why they wont just drop down any help??

  2. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

  3. Top | #2
    ttazzman's Avatar
    Join Date
    Feb 2019
    Last Online
    Today @ 10:05 PM
    Location
    sw mo
    Posts
    339
    Thanks
    14
    Thanked 46 Times in 32 Posts
    one reason a SA cylinder would not work correctly when attached to a hydraulic source would be that the cylinder itself is bypassing inside and needs to be resealed....or the vent is clogged or partially obstructed ....mine had a miniscule vent hole on a screw in a hex head bolt at the rear side of the cylinder (opposite end to the hose connection) to do the venting (didnt see it till it started leaking out fluid on the down stroke)

    i had one on brush hog wheels that got slower and slower and then started pushing fluid out the vent when on the down stroke in my case it was cheaper to replace the cylinder than it was to reseal the old one .....
    Last edited by ttazzman; 05-15-2019 at 01:48 PM.
    rtgt likes this.
    John Deere
    5105M
    2140
    4500
    Caterpillar
    D4Hxl
    416C
    Gehl
    5635DX

  4. The Following User Says Thank You to ttazzman For This Useful Post:

    terryknip (05-15-2019)

  5. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

Similar Threads

  1. Replies: 7
    Last Post: 12-08-2018, 07:59 AM
  2. Replies: 1
    Last Post: 11-18-2018, 09:05 AM
  3. Bleeding gate hydraulic cylinders on 535 baler?
    By Heath in forum Combines, Harvesters & Hay Equipment
    Replies: 5
    Last Post: 09-02-2018, 11:26 AM
  4. hookup a single acting cylinder implament
    By toy4wd in forum Hydraulics
    Replies: 5
    Last Post: 04-21-2016, 09:29 AM
  5. Replies: 8
    Last Post: 04-24-2014, 07:32 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •