Well, I finally got around (after 10 yrs ) to making a parking stand for my tiller. Used scrap steel I had laying around.. Works really good, might have to beef up one part in the future but gonna see how this holds up..

As you will see, I used a existing bolt to mount the angle iron, then used a 1 1/2 tubing as the upright and added a second piece of smaller angle to hold the tubing in place. I am not at this time gonna make anything for the front, the tiller seems to sit pretty level, and you have to tip it forward quite a bit to make it go over on its own. most of the weight seems to want it to tip backwards, so the rear stand alone should do the trick.. Its sitting on the tines, no skid shoes..

Click image for larger version. 

Name:	P1030143_zpsc4dd9a80.jpg 
Views:	58 
Size:	95.8 KB 
ID:	22713 Click image for larger version. 

Name:	P1030142_zps425a092e.jpg 
Views:	53 
Size:	79.4 KB 
ID:	22714

Tilling mode. To remove the stand, all I have to do is loosen the 1/4 bolt (finger tight) and take bolt and tube off.

Click image for larger version. 

Name:	P1030141_zps5183df0a.jpg 
Views:	47 
Size:	89.5 KB 
ID:	22716 Click image for larger version. 

Name:	P1030140_zps3da5b0e8.jpg 
Views:	40 
Size:	80.0 KB 
ID:	22715 Click image for larger version. 

Name:	P1030139_zps423daa15.jpg 
Views:	40 
Size:	57.8 KB 
ID:	22717