I have a 2016 JD 1025R with the 60D drive-over auto connect deck. I am looking at a used 14BU MCS bagger with a 60" Powerflow unit off a 2014 1025R with a 60" deck, but I cannot seem to figure out if this is the right powerflow unit or not. The problem is that it appears that there were two different versions of the 60D deck?? I have searched and searched here and all over the internet, called the JD dealer, etc. and I am no closer to an answer.
It appears that this powerflow unit is possibly for an "older" 60D deck for a 1025R?? It has a serial number that starts with 1GX700PF and looks like the rear mounting bracket will not fit my deck. I searched on this forum and found a thread that it appears that this <older?> style powerflow would mount the rear arm to a bracket added to rear where the rear bogie wheel is located. But there is no way it would work in that same location without cutting my deck or drilling holes which I know should not be the case. I have attached a picture of the used powerflow next to my deck and you can see it doesn't appear to be even close.
Is anyone familiar with this mounting? Does anyone have any pictures of the most recent design powerflow on a 60D deck? Any help would be most appreciated. Here is the thread I found that looks like there are two different 60D decks: