PTO Shaft Assembly for Model 40 tiller and JD 950
Results 1 to 2 of 2

Thread: PTO Shaft Assembly for Model 40 tiller and JD 950

  1. Top | #1

    Join Date
    May 2016
    Last Online
    08-01-2018 @ 07:23 AM
    Location
    La Porte, IN
    Posts
    18
    Thanks
    0
    Thanked 1 Time in 1 Post

    PTO Shaft Assembly for Model 40 tiller and JD 950

    So after two days of trying to connect to my 950, I concluded that perhaps the shaft assemblyis not working as designed. It only retracts about 3 inches so the spline end of the floating yoke is basically impossible to maneuver. I never thought to take the spline end of the arm from my woods mover and see if it fit onto the tiller UJ side, but is this something that folks typically do? If I have the same problem then I suspect that the UJ side of the arm is bent or damaged and that I should just by a entirely new shaft assembly? Any suggestions or recommendations on where to buy a model 40 tiller / 950 compatible arm? Thanks!

  2. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

  3. Top | #2

    Join Date
    Mar 2016
    Last Online
    Yesterday @ 08:32 PM
    Location
    Midwest
    Posts
    40
    Thanks
    5
    Thanked 2 Times in 2 Posts
    If the shaft will not collapse, slide together, likely it is bent. If the other shaft it identical size, shape and length you could try the end section. Usually if the shaft is bent, best solution is replace entire assembly. It needs to slide freely to avoid damage to implement gearbox or tractor PTO


    Sent from my iPhone using Tapatalk

  4. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts