I have a 4200 w/ a 420 loader. The tractor is equipped w/ the factory 3rd SCV plumbed to the rear - it is the kit that utilizes the 3rd spool on the factor SCV and is controlled with a handle on the right fender. I'm considering using this 3rd spool to control the chute on a #59 Snowblower. At this time, this option seems more favorable than a linear actuator and the wiring involved.
I was considering some long hoses from the blower to the rear. Then I noticed JD provides a set of hard lines, couplers, hardware, etc. for using the 3rd spool as a 3rd function on the loader for the 420/430/440/460/300CX loaders. (See image below). I believe this will work on a variety of tractors (4x00/4x10/30xxR and possibly others). I'm thinking of purchasing #13B (or fabricating something similar) in the diagram to make it a little easier and possibly cleaner installation.
I was wondering if anybody has this installed and if so, where does the bracket (PN W53059, #13) bolt to? Could somebody take a picture, please?
Thanks in advance.