GT235 Throttle linkage diagram
Results 1 to 2 of 2

Thread: GT235 Throttle linkage diagram

  1. Top | #1

    Join Date
    Nov 2018
    Last Online
    11-02-2018 @ 02:46 PM
    Posts
    1
    Thanks
    0
    Thanked 0 Times in 0 Posts

    GT235 Throttle linkage diagram

    Where can I find a diagram of the throttle linkages on the front of JD GT235 (M0G235F093906) w/ Kawasaki engine (FH580V-AS04)? We bought the tractor used. My grandfather (85) started taking it apart to get the busted muffler out, without me, so I didn't get any pictures (I always take picture because I can't remember anything). We can't figure out how to reassemble it. Specifically there is a sort of L shaped linkage arm that goes from the block where the cables attach to the carb, I think, that we can't get back in place to operate correctly. But ideally a diagram of the whole assembly as I'm not confident of the way he's reassembled some of it. I appreciate any help. Thanks

    EDIT: #1 in this exploded parts diagram: https://www.green-parts-direct.com/j...5-171297-68568
    Last edited by simsrw73; 11-01-2018 at 03:17 PM.

  2. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

  3. Top | #2

    Join Date
    Oct 2018
    Last Online
    09-02-2019 @ 09:18 AM
    Posts
    35
    Thanks
    0
    Thanked 4 Times in 4 Posts
    The service manual for the engine is available at mymowerparts . I can't lift the diagram, but here is the text for the static governor adjustment. Page 54 Best of luck.

    Governor Arm Installation
    •Install the governor arm [A] onto the governor shaft [B]
    temporarily.
    • Be sure the link spring [C] around the throttle link rod [D]
    is in place and that it pulls the governor arm and throttle
    lever [E] each other.
    • Loosen the clamp nut [F] on the governor arm enough to
    move the governor shaft.
    • Turn the top end of the governor arm counterclockwise
    to fully open the carburetor [G] throttle valve and hold it
    there.
    • Turn the governor shaft counterclockwise fully to the end
    of its travel.
    • Tighten the clamp nut.
    Torque - Governor Arm Clamp Nut: 7.8 N·m (0.80 kgf·m, 69
    in·lb)
    • Be sure the governor shaft extension from the governor
    arm is approximately 7 mm (0.3 in) [H] as shown in the
    figure.
    •Install the control panel assembly, and connect the governor
    arm with the governor spring.

  4. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •