I have done and replaced just about every thing to get this to work.The blades will not engage. New key switch ,rio switch,black box under dash what ever you call it. It will engage if I direct wire it to clutch . Can you just put a toggle switch on it with out hurting any thing ? It starts fine but can not engage blades.
Have you checked the safety switches themselves (brake, reverse, seat)? The switches could be non-operational (stuck either in open or closed position), or out of adjustment to actuate. Do you have a VOM or DVOM (Volt Ohm Meter or Digital Volt Ohm Meter)? Test the switches on ohm range/diode/continuity - Open is infinite ohms or OL - Closed is 0 ohms
Last edited by bloodrunsgreen; 12-20-2018 at 07:45 PM.