I removed my rops lights from my 1025r because they were going to get smashed by a tree and because I never drive on the road. I unplugged the wires below the rops and pulled the entire wire harness out with the light fixture.
I want to attach a sprayer with a small electric pump. I would like to plug it into one of the blinker wires and use the blinker switch to turn the pump on and off. Obviously I do not want my pump to cycle on and off like a blinker. Also I have not used a voltmeter yet to check if I have enough power. I want to use the blinker switch to activate the pump because it is in an easy to reach spot.
First the simpler question, should I have enough power at the blinker wire to run a small pump? Similar to this: youtube
Second, what do I need to do or remove to provide continuous power when i turn on a blinker?