How to change the 4wd shaft seal on a 650?
Results 1 to 2 of 2
Like Tree4Likes
  • 1 Post By Footy
  • 3 Post By Footy

Thread: How to change the 4wd shaft seal on a 650?

  1. Top | #1

    Join Date
    Feb 2014
    Last Online
    09-27-2019 @ 09:16 AM
    Location
    Matthews, NC
    Posts
    195
    Thanks
    0
    Thanked 17 Times in 14 Posts

    How to change the 4wd shaft seal on a 650?

    I am working on a 650. I would like to change the seal that is on the shaft that goes from the lower part of the transmission that spins the drive shaft to operate the 4wd front axle. This seal is in a narrow recess in the bottom of the transmission housing. It is much too small for a standard seal puller. I would say that the cavity is about 3 inches wide and 6 deep. Any advice on how to do this?
    pcabe5 likes this.
    2009 5045E
    1985 650 4 WD
    Big Dog X-1060

  2. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

  3. Top | #2

    Join Date
    Feb 2014
    Last Online
    09-27-2019 @ 09:16 AM
    Location
    Matthews, NC
    Posts
    195
    Thanks
    0
    Thanked 17 Times in 14 Posts
    Gizmo2, pcabe5 and Ray_PA like this.
    2009 5045E
    1985 650 4 WD
    Big Dog X-1060

  4. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •