I think that would be nuts.
Something like this would be more in line for pulling with a 2 series.
Wagons & Trailers
Last edited by coaltrain; 08-03-2017 at 02:22 PM.
It is what it is
Knowledge is power, ignorance is bliss
2520 w/200CX w/62D2
Depends on what you are putting in it and where you are going. It will likely pull a big trailer like that just fine but is it fully loaded with dirt, leaves or air? Really it comes down to how much of a load you are hauling.
JD Z950R 60" Deck with DFS Collection System
JD X585, 54C deck,
CTC Model X4750 F.E.L - Modified Imp Pressure Relief from 900 to 1175PSI, Power Flow and MC519 cart, 54-inch Quick-Hitch Front Blade, 47-inch Quick-Hitch Snow Blower, 3-pt hitch, HF Quick Hitch, Heavy Hitch, 48" box blade/rear blade, Dethacher, 3pt Sprayer
The empty weight of a 5x10 dump trailer as pictured will probably be close to what the 2038R weighs. So it won't take much of a payload to weigh twice the weight of the tractor. That could get a bit dicey in the stopping department depending on your terrain.
2012 2720 -- 200CX Loader -- 54" Quick Attach Snow Blower -- Frontier LR5060 Rake -- Land Pride RB1660 Blade (Hydraulic Angle) -- Artillian 42" Forks -- Ken's Bolt on Grab Hooks -- Fit Rite Hydraulic top-link -- 2013 X500 for mowing duties
I like pulling the trailer with a pickup and loading with the loader. If you are pulling with the tractor, that means pulling it to where you load and unhooking. Load the trailer but don't overload the jack. Hook back up again and pull the trailer to the dump site. Repeat as necessary.
If you decide to use your tractor, I would rig up manual electric brakes so you can stop the rig using the trailer brakes.
Let us know how it works for you.
John Deere 790, 300 loader w Ken's Bolt on Hooks & Piranha tooth bar, grapple, back blade, box blade, Bush Hog mower, couple of red tractors, hay equipment, various old stuff some red, one orange, some I don't remember
This is what I use behind my 2320, my side x side, and my pickup. https://www.sure-trac.com/products.php?trailerId=6
Hard to back with pickup because its so small, but the self contained hydraulic system/with remote requires no special hook up
on any vehicle.
I just use my loader.
1998 955, 70A Loader, 54 Blade, 72 Deck
1957 Farmall Cub - Technically belongs to my son.
If it ain't broke, You're not trying. - Red Green
2014 2032R tractor/H130 FEL w/Bolt-On Hooks/54" Snow Plow/iMatch Quick-Hitch/County Line 5' Scraper blade/County Line Carry-All/Artillian 42" Forks & QH Adapter/JD Ballast Box/Frontier SB1164 3PH Blower/Leinbach PHD/Wallenstien BX42 Chipper
1025R, H120 FEL, 60D MMM, Rhinohide canopy, iMatch, Frontier BB2060L, SS1067, RC2048, Heavy Hitch front weight carrier, subsoiler, trash bin carrier, rear hitch plate, Titan ballast box, 42 inch forks, Tarter chain harrow, Yard Tuff arena drag, DragnFly Arena Groomer, Newer Model 225 manure spreader, Ken's bucket hooks, Piranha tooth bar, Fimco 40 gallon 3pt boom sprayer,
The trailer I use has a 4' wide x 6' long x 2' high box. It's hydraulic dump run off my auxiliary hydraulic connection on the back of my 2320. It will haul 4,000 lbs of sand or gravel. I wouldn't want anything larger for this size tractor. The tractor, loader and trailer weigh right at 4,000 lbs empty.
2011 2320 w/R4's, 3rd SCV
imatch hitch. Soft side cab
47" front mount snow blower
200cx FEL w/ 54" dirt bucket - added a 1/2" x 6" DBL Bevel Bolt on Cutting Edge
42"tined utility bucket w/ grapple
54" JD 3pt blade w/ hydraulic swivel
Hydraulic Dump trailer 48" W x 72" L X 24" Deep w/cap of 4500 lbs
2011 D110 w/ bagger, 42" 2-stage blower
2016 x380 w/ 48" deep body deck and powerflow bagger
91 STX38 - this was my Father-in-Law's lawn mower