Had both of my hydro lines leaking at the swivel point on my JD 316. I checked around and found either nobody had the correct fittings or they were way too big. It was already a tight squeeze. Decided to order right from the dealer. OEM part, correct fit, right? Nope. Looks like something I could of had made! My question, anybody ever deal with this? Any suggestions? This seems to be the only way to install them. Same as the factory lines were installed. Can't run one the other way because the linkage, driveshaft and trans filter all cause issues. When I put the rear fenders on, that line sits up so high, it hits. Frustrated.