Oil filter adapter bolt torque Z665
Results 1 to 3 of 3

Thread: Oil filter adapter bolt torque Z665

  1. Top | #1
    Hurlsroxatfatchx's Avatar
    Join Date
    Jul 2018
    Last Online
    Yesterday @ 10:30 PM
    Posts
    12
    Thanks
    0
    Thanked 1 Time in 1 Post

    Oil filter adapter bolt torque Z665

    Good evening. I have a Z665 with a Briggs & Stratton 27hp motor. My stump gasket is leaking so I'm going to change it as well as all other gaskets and o-rings just to make sure I don't have to take the motor off again anytime soon. I'm going to change the o-ring behind the oil filter adapter but cannot find what the bolt should be torqued to. I have the technical repair manual but can't find it mentioned anywhere. Thank you for your help.

  2. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

  3. Top | #2
    xcopterdoc's Avatar
    Join Date
    Jan 2012
    Last Online
    Today @ 07:38 AM
    Location
    nc
    Posts
    1,674
    Thanks
    212
    Thanked 892 Times in 335 Posts
    I just did one also. Could not find the torque either. Just use common sense and snug it up. You should be fine.

    Sent from my LGL52VL using Tapatalk

  4. Top | #3
    Hurlsroxatfatchx's Avatar
    Join Date
    Jul 2018
    Last Online
    Yesterday @ 10:30 PM
    Posts
    12
    Thanks
    0
    Thanked 1 Time in 1 Post
    Thanks for your reply. I was planning on using the same torque as the oil pump cover which is 50 lb.-in. since they both use similar o-rings.

  5. Remove Advertisements
    GreenTractorTalk.com
    Advertisements
     

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •