Search Results for ‘322’

I'm having an issue with my John Deere 322 stalling out. It'll run great for 5 minutes, then it stalls out. If I throttle down and/or disengage the mower deck, it runs a little longer. Pulling out on the choke seems to help at times too. I just changed the plugs and checked voltage to the...

I just got my 322 re-assembled after rebuilding the steering cylinder. When I went to start it, I experienced some hydro-creep, so I set the parking brake (my 322 either doesn't have the parking brake switch or it's been jumpered out). When I set the parking brake, the starter began to grind...

Hi everyone. I'm a proud owner of a 1988 John Deere 322 and a 1987 John Deere Hydro 185.

I have a 322 that sprung a gusher from the steering valve assembly. One "O" ring was replaced which helped, but it is still leaking a bit. Are there parts available for this? Also, the Serial number tag is missing off of this, and I am wondering if there is another location on the tractor where...

My 332 in my opinion doesn't move as fast as it should when moving forward. Reverse seems ok and is definitely faster than reverse. Can someone give me some guidance? I know there were 3 or 4 versions of the transmission control linkage based off the serial # tag but mine is missing. The...

Good morning, I have a JD 332 with a M0048DC 140/318 replacement deck. I'm looking to install a power flow bagger and I need to replace the single pulley with a double pulley to power the unit. Does anyone the part # for this pulley? Thanks in Advance

I recently picked up a 332. It fires right up and runs great. However when you move the hydro lever forward the tractor moves but not very fast. The same happens in reverse. The hydro lever feels sloppy and just not right. I pulled the fender deck to get a look at the linkage. Are there...

Greetings from Oregon. I have a new-to-me 322 and can't get it started. We have replaced the starter, cleaned out gas tank, new fuel filter, checked compression (150, 150, 130), and it seems to have spark, but it just won't start. Any suggestions? I have seen posts about the sensors for the...