Search Results for ‘3720’

I'm planning to buy a 3720 that comes without front loader. The tractor is today equipped with a hydraulic plow so the hydraulic connections are already there. I think I have to mount some kind of brackets for the loader? Is there something else to take into account for this operation?

Hi GTT friends, I have for sale the Rock Shaft Assist mounting kit LVB25611 for sale. It's brand new old stock, with some dust and marks from storage. Retails for about $1200 plus freight in Aust, I'm asking $800 plus freight. If you would like to fit a 48, 448 or 485 backhoe to your 3X20...

2013 John Deere 3520 Only 116 Hours. 300CX Loader, Always garaged. Runs excellent. 73" HD loader bucket Asking 20,500

Hey guys, Looking for some help here. I am working on a 3720 that starts up and runs fine for anywhere from a few minutes to a half hour and then dies. after it dies i crank it for several seconds, sometimes it starts and dies again, other times it takes several tries cranking and it will start...

Has anyone adjusted the valve lash on a 3720? My dealer says they have to pull the whole tractor nearly apart to do it. It would appear to me that it can be done with little or no disassembly? Any suggestions on how hard this is to do or how to go about it.... hate to pay over a $1,000.00 to...

I need to remove the rocker arm cover and our dealer implies you have to pull the fuel tank - the manual does not say that but says to pull the muffler.... from looking at the engine I think neither need be done to adjust valve lash - has anyone done this job and if so what do you suggest.

Hi everyone, This is my first post. I joined just about two weeks ago and I have been reading some very good stuff so far. So I thought I would see if anyone else owns a 375 backhoe and has had a problem with the retaining pins snapping. The retaining pins that I am talking about are the...