Green Tractor Talk banner

Discussions Showcase Albums Media Media Comments Tags

1-11 of 11 Results
  1. Large Frame Compact Utility Tractors (LCUT)
    My tractor will only move in high range. When I put it in B or A the tractor boggs down and will die. Does anyone have any ideas of what the problem could be?
  2. Large Frame Compact Utility Tractors (LCUT)
    I got a 4310 with a fuel gauge that always shows full. It goes back to empty with key off. I am getting the correct feedback from the float in the tank. My question to the group, has anyone ever been able to repair a stock JD instrument cluster? and if so what was the issue. I have read...
  3. Large Frame Compact Utility Tractors (LCUT)
    Recently picked up a 4310 eHydro that runs but will not move..... Common issue with these age machine. Previous owner said he tore off the wiring harness below the foot pedals and it never moved since. I repaired all the wiring but cannot get it to go through the calibration. I'm trying to get...
  4. Large Frame Compact Utility Tractors (LCUT)
    Any common reasons why it will blow this fuse? It blew last year some time. I replaced it and have probably put 50 hours on it no problem. Today, I tilled a few gardens with it, no problem. Went to fire it up to move some dirt and it hasn't ran for more than 30 seconds without blowing a fuse...
  5. Implements & Attachments
    Introduction Here is the saga of my backhoe install. It’s pretty long, but I hope that future readers will see that it’s possible to keep these older tractors working if you do the research. Keep in mind when you look at pricing, that the Australian dollar values are roughly double the USD when...
  6. Large Frame Compact Utility Tractors (LCUT)
    Greetings from PA! New forum member here, and I come to you all with a question I stumped with. I'm a brand new owner to a 2002 4310 E-Hydro. I picked it up with a 430 FEL, and a JD47 Backhoe frame mount. 1330 hours. Aside from being normal tractor dirty when I picked it up, it runs out real...
  7. Large Frame Compact Utility Tractors (LCUT)
    I just purchased a used 4310 at Auction, it came with a snow / dozer blade but not mounted. I can't figure out if it is the right setup for this tractor, the mount pins on the fram are too far apart (front to back) Looks like it might be for a larger tractor and the seller might have just thrown...
  8. Large Frame Compact Utility Tractors (LCUT)
    How can I test this module (LVA11884) to see if it is good? A few years ago, when my tractor wouldn't start (or would start only sometimes), I checked several things on it and ended up changing this module. It then started and ran perfectly until a few days ago. It was running fine, I parked...
  9. Large Frame Compact Utility Tractors (LCUT)
    Going to put a block heater in my tractor but I need to move a "Suction Tube Manifold" hose before i can get to the drain plug to remove it. Here is a pic of said hose, has anyone ever taken one off before? What should I expect as far as fluid loss......or any other surprises that i may not be...
  10. Large Frame Compact Utility Tractors (LCUT)
    2004 4310 eHydro, forward motion stopped after 5 minutes of using Brush Mower. Bucket , 3 point hitch and pto still worked. The only movement of the tractor comes if after starting you press the reverse pedal first, it will still go in reverse after stopping once, but if you stop a second time...
  11. Large Frame Compact Utility Tractors (LCUT)
    Hello everyone, I recently purchased a Frontier BB2172 for my new to me JD 4310 tractor. I’ve gotten a lot of good hours repairing and maintaining my road and the neighbors. There is a learning curve getting the angles right and road crowned properly, I’m still a novice but every attempt gets a...
1-11 of 11 Results
Top