Green Tractor Talk banner

Discussions Showcase Albums Media Media Comments Tags

1-10 of 10 Results
  1. Utility Tractors
    Hello from Mebane, NC. I have a John Deere 2240 that when I have the rock shaft in the top two depth notches the 3 point will raise all the way up and not come down. I can't seem to find anything on the internet about this happening and wondered if anyone had any thoughts. Thanks in advance!
  2. Agricultural Tractors
    I changed the load shaft and seals on my 4430 the end of July 2020. Haven’t used the 3 point since. Today 9/29/20 while pulling a grain drill the seal on the left side started pouring. Why??
  3. Agricultural Tractors
    I have a 4230 quad range that I recently put a new main hydraulic pump and transmission pump in and it seemed to be working good. Now only about 100 hours later it doesn't have nearly as much flow as before and when I use the PTO and shift between the high low it shuts off. It still has 2300psi...
  4. Large Frame Compact Utility Tractors (LCUT)
    Hey everyone. New to site and looking for some advice and/ or opinions. i had a 2009 3320 which is and was a great tractor for me. I didn’t have to do anything to it other than routine and annual maintenance.I recently traded the 3320 for a new 4052R. I like the tractor. But so far it hasn’t...
  5. New Member Introductions
    Hey everyone. New to site and looking for some advice and/ or opinions. i had a 2009 3320 which is and was a great tractor for me. I didn’t have to do anything to it other than routine and annual maintenance.I recently traded the 3320 for a new 4052R. I like the tractor. But so far it hasn’t...
  6. Hydraulics
    Hi guys, I'm new to this forum, so if I make some mistakes, please understand me. So I have a hydraulic problem with this old JD. Everything worked fine until a week ago, when oil started coming out from the gear lever area and I saw smoke coming from the hydraulic pump in the front. The result...
  7. Medium Frame Compact Utility Tractors (MCUT)
    Snagged a root with the hydraulic line (part #LVA802862) coming of the outside of my filter. It pulled out of its bracket and into my u-joint which promptly wore a hole into it. Got the replacement pipe in from my local dealer and started digging into the tractor to remove offending part but I...
  8. Sub Compact Utility Tractors (SCUT)
    Anybody know what might be the cause of the hydraulic connection not seating into the female connection. Two of my four connections will not engage into the female hookups. The othe two work just fine in all of the female connectors. Just thes two will not completely engage in any of the females...
  9. Large Frame Compact Utility Tractors (LCUT)
    I have a recently purchased 4210 with a 420 loader and noticed that the bucket will not hold it's position. From suggestions I have pulled the quick-disconnect lines off to isolate the bucket from the controller, same problem, the bucket slowly drops down. Have re-built the cylinders and now...
  10. Utility Tractors
    6420 with 4k hours. hydraulic oil filter changed 10 hours ago. i wasnt in the tractor when problems started. It was a family friend who is almost deaf, so if a noise occured during the problem then he didnt hear it. We were running a 7200 planter with the vaccuum hooked up to a valve and the...
1-10 of 10 Results
Top