Green Tractor Talk banner
hydraulic
1-17 of 17 Results
  1. Lawn & Garden Tractors
    Hey, so I am in the first year of ownership, and this is the first winter using the x595. I don’t have anything to do with it over the winter so I thought it’s a good idea to start it up once a week and let it run for 15-20 min to keep it from having a drained battery. There is a high pitch...
  2. Implements & Attachments
    I am attempting to get ready for the winter and trying to attach the front hydraulic bracket to attach the snow plow. Where am I going wrong? How should this attach to the front bracket?
  3. Converting JD Material Cart to full Hydraulic

    Just wanted to share a quick video on converting a John Deere 519 Material Cart to full hydraulic. In the video I give information about specific parts and materials that I used to complete the project. When I viewed other posts they didn't really show the need to reinforce the cart because it...
  4. Hydraulics
    I have a JD 1023e (2012) and just this fall, the hydraulic cylinder controlling the lift/drop of my 54D mower deck became a slow as molasses, and is getting worse, to the point of barely working at all. The mower lift/drop is controlled by the SCV. I'm not even sure where the hydraulic cylinder...
  5. Hydraulics
    Been searching and searching for the fitting size/type that fits this hose that goes on a mid-mount scv on power beyond. It goes on 5055e but it also used on other models. Any help would be greatly appreciated. Thanks Scott
  6. Large Frame Compact Utility Tractors (LCUT)
    The 3-Point on my 3520 (2007, 1500 hours) has developed a problem where it will sag at a fairly fast rate. I typically keep a weight box on it and if the tractor is shut off, it will drop 1" per minute. If the tractor is running, it will adjust up about every 30 seconds to keep the set height...
  7. Large Frame Compact Utility Tractors (LCUT)
    Hello everyone. I recently had a chance to use my brand new 485 backhoe that is attached to my 2006 4120. The hoe has a production date of 2018 but still brand new unused condition. I am noticing something that I dont think is normal. When I crowd the bucket from the teeth tips straight up and...
  8. Large Frame Compact Utility Tractors (LCUT)
    OK, first a little background -- So, when I ordered my 4105 back in 2014, I skipped the factory-installed rear SCV -- a short-term thinking problem I struggle with a lot...I once factory-ordered a car with no AC...😳 Fast-forward to 2019, and I decide that a hydraulic top link on my 3-point...
  9. Large Frame Compact Utility Tractors (LCUT)
    I need to have hoses made up to run from the rear quick attach female connectors to a front grapple. What type and size male connector is required to fit the 4720 JD rear QA ports? Is there a preferred brand connector? Also, what hose diameter should be used for this intermittent, low flow...
  10. Sub Compact Utility Tractors (SCUT)
    MY lift arm on my 650 compact tractor will not raise or does so very slowly. I changed the hydraulic filter and have checked all the hydraulic lines for crushing or restrictions, checked the lift valve for flow and made sure the lift know was opened all the way. I don't know if this is a pump...
  11. Lawn & Garden Tractors
    I noted a whining noise in the p/s and deck position hydraulics and saw that the reservoir cap had popped off thus allowing the hypo oil to leak out over time. I filled the tank which initially took are of the noise, but it comes back after restarting the tractor the next day. Goes away after...
  12. Sub Compact Utility Tractors (SCUT)
    Hello all, This is my first post here as a newbie tractor owner and I'm so glad to have found this place! I purchased my first tractor a couple of weeks ago, a JD 2210 with 400 hours. I just made room in the garage to keep it and removed the 62" mower deck for now. I noticed that there was a...
  13. Large Frame Compact Utility Tractors (LCUT)
    I have a recently purchased 4210 with a 420 loader and noticed that the bucket will not hold it's position. From suggestions I have pulled the quick-disconnect lines off to isolate the bucket from the controller, same problem, the bucket slowly drops down. Have re-built the cylinders and now...
  14. Large Frame Compact Utility Tractors (LCUT)
    I have a JD 3032E, I have installed the rear hydraulic remote Kit, went quite well. I want to ask if anybody knows what make the D160 loader valve is and is the rear remote the same make. I have looked all over for the manufacture of the valves and have found nothing. I wanting to install a...
  15. Sub Compact Utility Tractors (SCUT)
    Hey guys, Yesterday after mowing for 3 hours I went to reattach the backhoe and the power beyond connectors were hot to the touch. Not so hot that I couldn't connect the backhoe but hot enough to be uncomfortable and make me do it fast. I'm at 103.5 hrs and did the 50hr service, about to do...
  16. Tractor & Equipment Maintenance
    After recently re-attaching my front loader, I had a leak at one of the quick connects. I've been using this style of quick-connect for almost 30 years and never had one leak like this. I disconnected it and reconnected it with no effect. I always clean the male connector before inserting it...
  17. Combines, Harvesters & Hay Equipment
    I have a 2270 swather that the header will not raise and lower. The book said to check port D on the controller to make sure it has 2000 psi pressure. It has none. Does the charge pump provide the pressure? I have changed the filter. If anyone has any suggestions, it would be greatly...
1-17 of 17 Results
Top