Hello. I recently inherited a 1999 5310. Tractor starts and idles and temperature gauge starts to climb. Ran it for a few days and it would run normal some days and read in the red other days with no apparent rhyme or reason. Then it stopped running normal all together. Now, as the engine...

This is a last resort: I bought an X-758 4WD diesel mower 4 years ago at the end of the mowing season. No problems with the first 1-2 times I used it. In the spring I started mowing but the motor would overheat and shut down the cutting deck. Short story is, 5-6 trips to the dealer,over the...

Has anyone ever encountered what appears to be an overheating problem like this. My John Deere 445 Temperature gauge will slowly go into the red zone (overheat zone) only after about 1 minute of running from being stone cold. I say intermittently – because after it happened last weekend, I...

Just purchased a 2440. Everything looked good, no leaks, smoke or serious obvious problems except for broken differential lock pedal which I would like to address later. Brought it home and drove it around for a few minutes. Decided to brush hog a small area and it worked fine for a little...

I have a 2018 2038R that is overheating and throwing an ICC 110.00 error a few minutes after starting and raising rpm to pto speed of 540 (even without the pto actually engaged. All fluid levels are fine, and the radiator and front grill are clear. Anybody have any thoughts about what could be...

I have a 2955 that overheated after being run for 10 minutes yesterday. I could see where there was coolant that had leaked so I let it cool down and removed the fill cap. Reservoir was about 3/4 of a gallon low, so I filled to the mark and started the tractor again with the heater blowing on...

Hello Everyone, Wondering if anyone has some ideas.... I have a 88 John Deere 318 that was rebuilt about 5 years ago. I use it over the winter for snow blowing and last weekend I put the deck and bagger on and did the first pass on the lawn. It seems very underpowered and the blades would...