Search Results for ‘rotary cutter’

Hi folks, I've now done about 5 hours of hard brush cutting with my new RC2048 (slip clutch). It's done a lot of work. I have two questions. 1. Do the blades swing freely or are they supposed to be totally rigid and set in place? I'm under the impression they are supposed to swing freely...

All, I have an RC 2048 Frontier Rotary Cutter and it's getting to cutting time. I purchased the thing last year and need to adjust the slip clutch. I have misplaced my manual. Does anyone have an electronic copy? The JD website is awful. When you search you end up with over 300...

Narrowing my search to the 48” King Kutter rotary cutter for my 1025R. Anyone have any experience with it? Thank you...

Looking for advice on whether to go with a shear pin or slip clutch on a 4 ft rotary cutter for my JD 1025R. I’ve been reading about advantages and disadvantages to both so would appreciate learning from your experience.

I am look8ng for a rotary cutter for my 1025R. In researching different options I found the Frontier RC2048 to be quite a bit more expensive. I looked at the 4’ Bad Boy today and was impressed with how sturdy it was weighing in at 600lbs and 2” cutting capacity plus the price was very...

My rotary cutter is dragging in the front and is causing ruts and sometimes the tractor gets hung up and doesn’t have enough power to pull. Am I doing something wrong? I hook it up when it is fully on the ground, should I prop it on blocks before letting it down and unhooking? Would that even...

Purchased a 1025R several weeks ago, which hopefully will be delivered tomorrow due to holidays and multiple dealer issues. I need a rotary cutter, but can't decide between 48" 54" or 60". First thought is the Frontier 48" but 1025R is right at 48" wide, and am concerned about ability to mow...

I have a 403 rotary cutter. Has less than 10 hrs since purchased new in about 2000. In like new shape, ready for use. Stored under a shed area. Asking $850.

Hello I am looking for some information on a rotary cutter I just purchased. It is a 4' John Deere model 54. I have found the unit on the John Deere parts website and a few other parts websites, but I cannot find any specs on the unit. It looks fairly well built, but I wanted to know if it is...