Search Results for ‘solenoid’

Greetings I put my mower deck on and am getting a PTO coil fault error on the console. I cleaned all electrical contacts related, tried to engage the PTO switch in the three position settings, installed a new pull switch, and finally purchased a PTO solenoid--figuring that is about the last...

Hi Guys - I have a JD 445 and I'm having issues starting it, when I turn the key fuel pump engages and dash lights come on, but it only turns over 1 out of every 10 times (at best). I replaced the battery and that didn't help. I discovered that if the key is in the "run" position it will start...

2005 hydrostatic 4110 tractor w loader and mid mount mower died while cutting field the other day. Cranks over but won't fire. I came back in evening and it fired up, drove back to house then quit, it started one more time and only ran briefly. I was thinking clogged fuel filter, so I put in a...

I have an odd one for everyone that involves my John Deere 4400 tractor not shutting off by the ignition switch. I can turn the key to the right, the dash comes up, gauges move, turn to start position and the tractor fires up with no problems. Controls and gauges work as they should. When it...

I recently bought a 2008 4720 cab with 900 hours. I am having a recurring problem with the pto. It came with a mid mount mower. Every time I mow with either the mid mount 6' mower or my 7' brush hog, after about 20 mins of mowing and I disengage the mower (pushing the yellow switch), the pto...

We have a 2653B Trim and Surrounds Mower. It will not start. We have gone through most of the diagnostic tests included within the technical manual. Everything has tested within parameters with the exception of the fuel shutoff solenoid. The manual states that when testing the solenoid...

Ok so here's the story, bare with me. I was bush hogging yesterday and was almost done. Tractor had been running fine for a couple hours. The fuel gauge was down near 1/8 of a tank but I only had just a small area left so I was trying to finish. We'll all of a sudden the tractor starting bogging...

My x300 has a Kawasaki iTorque twin that will not start unless the choke is full on. Once started, no choke is required and it runs just fine. I can run this thing for a half hour, shut it of and then immediately try to restart it and it won't start unless I give it full choke. Once started...

I have a 6400 with loader, solenoid clicks when I try to start. Can jump across terminals then will start off key a few times, then back to clicking at solenoid. Bought two new solenoids none fit, and cant figure out how they come off, without removing starter. Is there a relay between...