Hi all. New user here! I got my 1023E back in May and have about 36hrs on it now. Everything is going great. The other day I was doing a job moving dirt and the control handle to raise and lower the loader got loose. I turned it clockwise to tighten it but now it is in a different position. I am wondering if there is a nut on the bottom of the handle to tighten it so I can put it in any position or if the bottom of the handle is threaded and screws directly into the hydraulic control valve. I kind of don't like where the position is right now because it is too far to the right. I am hoping it does not screw directly into the control valve because I would think that means that the bottom portion of the threads are now stripped. I did not try to unscrew it or do anything to fix it until I look into it first. Thanks in advance!