Green Tractor Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
338 Posts
Discussion Starter #1
I was wondering if I can use the front drive shaft from my X728 to run a snowblower for a 1025R or if there is a big difference.

Thanks

Adam
 

·
Super Moderator
Joined
·
8,053 Posts
I was wondering if I can use the front drive shaft from my X728 to run a snowblower for a 1025R or if there is a big difference.

Thanks

Adam
You never know.There may be different part numbers for the implement drives due to the unstop or hydraulic extension hoses being different between the X728 and the 1026. I'd say mount it up and check the driveshaft length, As long as it's not fully compressed (too long) or fully extended you may be A-OK. If the driveshaft is too long you won't be able to engage the lower mounting pins into the blower housing. Move the lift throughout it's entire range and make sure there's no binding.
 
1 - 3 of 3 Posts
Top