Green Tractor Talk banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
162 Posts
x2 on the ez pour....probably have half a dozen of that type conversion to existing plastic jugs and newer jugs I had whose spouts were way past their prime or unworkable upon purchase....
I bought some kits for the new jugs that you can buy with the JUNK filling spouts that included new spouts & their locknuts (caution: YMMV on the thread!) and a push-in (after you make a tight fitting hole) vent plug for the rear of the jug....problem solved.....I did make a couple of aluminum nuts to hold the new spouts tight to the jug threaded neck.......THANK YOU CARB & our governments in general for being so mindful of our safety.........& an especial thank you for the ethanol'd fuel.......
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top