[csnyder750]

It appears the knob on my 1025r mower deck is off by a turn.
With the deck fully up.

Turn the knob fully counter clock wise and I end up at 4 position.
- I expected it stop at the fully ground level remove your deck position.
Turn the knob fully clock wise and I end up at position 3.
- i expected it to stop at position 4

Are my expectations wrong or is there an adjustment i need to make ? I've pulled the knob off but apears that it has to be put on in the same position

thanks

I just adjusted mine last week. When I rotated my knob it would stop. thats not right. you should be able to rotate your knob 360 degrees in both directions without it stopping on its own. you set it to 4 it should be on 4 position. if not you need to adjust it. (it could be your sticker is off too. Someone here ordered a new sticker and put it on correctly.

But if you spin your knob in both directions and it "stops" on its own you need to adjust it. it should spin freely.