Green Tractor Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,356 Posts
Butch, An idea that may or may not work !
First, try to straighten damaged new seal as best you can, then get a gear type radiator clamp, NOT the wire type pulled together by a nut & bolt. Put a few layers of electrical on the inside of the clamp... to cover the teeth slots and make it slipperier..., lube OD of seal and tighten clamp around old seal, TIGHT! Lube seal and try to tap seal out of clamp and into bore. A punch or dowel will work and I've even used the head of a nail! If you can get seal 1/2 way in, call it a success, remove seal and install new seal when received. Bob
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top