Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1 (Edited)
I have a 3rd SCV on my 1025R and notice this weekend my hydraulic hoses were rubbing on the 3 point hitch. When I have my rear blade connected that I have a hydraulic cylinder for the angling of the blade. I removed the bracket that holds the hydraulic couplers and bent the bracket to angle the hoses away from the 3 point hitch. If you have this option take a look at this when the 3 point is full up.
F6215C52-E9FF-4DAE-94CB-A7F9D2549B0B.jpeg

D2FC480B-A213-43A2-AA20-B89ABDCC6F8A.jpeg

6D92B105-16A7-47B4-ADD6-83A3E1294AC1.jpeg

04FA1EEB-28AA-4E96-8BF8-B943A9D9050C.jpeg

54D2C02A-6C20-4A2D-9E96-B9CA4F1A628B.jpeg

05E9FF30-F905-4AA3-A605-B64F6059C3AA.jpeg
 

·
Registered
Joined
·
285 Posts
Thanks for the heads up. If I ever decide to fabricate a hydraulic cylinder for my rear blade I will keep this potential problem in mind.

I have the backhoe so I have the "Power Beyond" connection. I've researched in the Hydraulics section but it seems like it may be a bit too hard for me to accomplish. Sure would be nice though!
 

·
Registered
Joined
·
420 Posts
Not to hijack your thread but I too had a 3D function hydraulic problem with the kit I just purchased from Artillian. I have a 2018 1025r with the 120r loader. I was having my dealer install the kit while they were doing some other work. The supplied bracket was a problem and my dealer had to move everything about 1 1/2” and make a new mounting plate. I thought that the Mauser cab might be the problem but there was no mention of a Mauser cab exclusion by Artillian.

I sent an e-mail to Tom at Artillian to let them know of the issue and told them to contact my dealer if he had any questions. I got a response from Peter that he doesn’t think the Mauser cab is the problem but the loader is. Don’t know about that because I purchased the 1025r kit they had listed. Anyways, Artillian is aware of the issue and I hope they take whatever steps necessary before anyone else purchases the 1025r kit being a Mauser cab or 120r loader issue.

All finished now and I’m happy with the results. I now have down pressure with the CTA plow and will be all set for a grapple in the future. WooHoo!
 
1 - 4 of 4 Posts
Top