Green Tractor Talk banner

1 - 1 of 1 Posts

·
Registered
Joined
·
716 Posts
Discussion Starter #1
I found the seat on my 1026 leaned back too far so I made these adjustment screws to raise the rear of the seat. I drilled and tapped 2 8mm holes in the seat frame just above the rubber seat stops. I then welded large body washers to the bolts so when the seat comes in contact with the rubbers it distributes the weight evenly. The bolts have jam nuts so i can adjust the seat back height if necessary. Not the best picture but you get the idea.

Sent from my XT901 using Tapatalk 2
 

Attachments

1 - 1 of 1 Posts
Top