Green Tractor Talk banner

1 - 5 of 5 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
i was doing a little house keeping on the pc and tripped across these pics from the early days of my 2210 ownership
at the time the cost was an issue as power beyond did not yet exist

but one owner had it done custom(pic's below) and CCM was making a kit for the 2210/2305

what would be needed for a 1026r to add 2 remotes inline with power beyond for us 260 owners?

i understand the tilt cylinder would need to be fabricated - it looks like the overall lenght is 8"

pics
471165-TopnTilt 001.jpg
471166-TopnTilt 002.jpg
471167-TopnTilt 003.jpg
471168-TopnTilt 004.jpg
471170-TopnTilt 005.jpg
471171-TopnTilt 006.jpg
471172-TopnTilt 007.jpg
471173-TopnTilt 008.jpg
 

·
Administrator
Joined
·
20,677 Posts
My future plans included adding a 2 spool valve for rear SCV's, specifically for top 'n tilt and whatever else I need rear outlets for.

I'm interested in what you come up with. :munch:

Have you looked around in the hydraulic section? There are more than a few threads that you might find handy in your quest.:thumbup1gif:
 

·
Registered
Joined
·
2,765 Posts
I too would like to add 1 or 2 SCV's to the rear of my 1026.
 

·
Administrator
Joined
·
17,954 Posts

·
Premium Member
Joined
·
2,899 Posts
I hope to use my power beyond to feed an addtional 3 valves, one for the upper link arm, and two for the snow blower chute rotation and deflection for when I get the snow blower. I hope I can do that. Now that I see this post with the tilt idea I think that would be great for the back blade to cut into banks etc, or with a box blade as shown for the same thing.
 
1 - 5 of 5 Posts
Top