Didn’t really notice change in performance. Was dozing some loose limbs and brush up into a burn pile. Was digging out some grubs and pushing dirt in low places. Swapped to BH to dig up some stumps and small trees. I was using the loader to scratch out dried clay on a couple of large stumps, trying to knock the dirt off the stumps to burn better. I rolled them over to loosen up the dirt when I noticed the loader booms would only raise about 5feet. I wasn’t really banging around on it or abusing it. Seems like it doesn’t power down when scraping or back dragging. Could I have bent something? I climbed off gave a quick once over. Nothing obvious was tweaked. Everything looked square and flush. Maybe all you wizards can put on your pointy hats, grab your staffs and send me down the path of all knowing remedies to help cure my loader gremlin. Watcha think?
Mike21
Joined
·
4,438 Posts
The oil seems to lose performance when it gets super hot. Maybe see how it acts once it cools down ?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
