Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello all, I have been searching this forum and all of the google, and have been unable to get a clear answer. Here is what I have going on.

Recently purchased a 1979 Model 850 tractor. it came with a brush hog, and that was the extent of it. On Monday, I was able to locate and purchase a Model 75 FEL , that came off an 850. It included the SCV. I know the tractor the bucket was on, was a 4x4, and based off the hard lines and photos on the internet I have seen, it was also equipped with power steering. I however, do not have power steering.

I was able to mount the bucket with little issue, and have the SCV mounted where it belongs on the right side of the seat. What I need help with, is plumbing this darn thing in. I do not have the power steering option, and therefore, do not have the right angle fittings on the front of the.. rock shaft, i believe it is called. I also cannot seem to find where the tank return line, and the other line, that goes to the left side of the transmission case, is supposed to be plumbed.

She seems to be a solid old girl, and I think if I can get this running, and get a back hoe setup, I will be less then half price into the tractor for the new one I was looking at getting. I know I will have some drawbacks working on an antique, but it is not something I use to make money, or keep a farm running. So saving 15k sounded pretty good to me.

Thank you in advance!

Tim
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thank you! I will have another look at it this week with your diagram to see if I can figure out what needs to go where. I will post results! Thank you!!!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top