Joined
·
2,527 Posts
On a Gen 2, which I own there is a little hole you are suppose to go through. I use this as a viewing port to line the grease fitting up with the nozzle on the grease gun. You can spinn things over by grabbing the flywheel and turning it. I then go through a slot near the hole where some lines go up and pull them out of the way to get on the grease fitting. This takes me anywhere from 5 minutes to 15 minutes to accomplish.
There are a lot ways to do this, one common way is to drill the hole larger. Lots of threads on this.
There are a lot ways to do this, one common way is to drill the hole larger. Lots of threads on this.
