2032R dual rear scv leak

1584 Views 11 Replies 7 Participants Last post by userjh161, May 17, 2021

userjh161

Discussion Starter · May 16, 2021

Yesterday when adjusting the hydraulic top link I noticed a steady stream of fluid running out of the right fender liner. Took it off today and this fitting is leaking when I hit the lever to shorten the top link.

It was finger tight when I got to it. I tightened it down as much as I could and slowed the leak, but there is still a pretty good amount where the 90 deg fitting enters the body. The nut is tight but it seems like the 90 deg fitting needs about another quarter turn to seat, but, it won't align with the hard line anymore if I do that. Any ideas?

Sent from my SM-N970U1 using Tapatalk

See less See more

Save

1 - 2 of 12 Posts

SRG

· #4 · May 16, 2021

Are you not able to hold the 90 with a wrench, while you crank on the nut?
You should be able to get an open end wrench over the 90, right underneath where your finger is in the top pic.

Save

Reactions: 1

SRG

· #9 · May 16, 2021

Zebrafive said:
I am betting damaged or missing O-ring. Let us know what you find.

Be my guess as well. Not much else to it.

Save

Reactions: 1

1 - 2 of 12 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month