Green Tractor Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter · #1 ·
Just finished replacing hyd fluid and filter. After cleaning out the screen and magnets at the rear of the machine I replaced the screen using a new rubber o ring (# M801034). I had a very hard time keeping the o ring in the groove while bolting the screen back in place. There is a small leak there now. Dose anyone know the proper torque value for the two bolts holding the screen in place. I want to check that before I drain fluid and fight with the o ring again. Thanks.
 

·
Registered
Joined
·
93 Posts
Discussion Starter · #2 ·
Just finished replacing hyd fluid and filter. After cleaning out the screen and magnets at the rear of the machine I replaced the screen using a new rubber o ring (# M801034). I had a very hard time keeping the o ring in the groove while bolting the screen back in place. There is a small leak there now. Dose anyone know the proper torque value for the two bolts holding the screen in place. I want to check that before I drain fluid and fight with the o ring again. Thanks.
I just found the torque values in the owners manual.
 

·
Registered
Joined
·
93 Posts
Discussion Starter · #5 ·
Thanks for the good ideas. I'll use some grease or gasket adhesive. The cover does need to come off to get to the o ring. Lots of fluid loss. Trying to figure out the best way to drain the new fluid back into the 1 gallon jugs it came in. Probably use a very clean funnel and make sure the area around the drain is wiped off clean.
 
1 - 4 of 4 Posts
Top