Green Tractor Talk banner
1 - 2 of 2 Posts

· Registered
Joined
·
64 Posts
Finally got to the dealer today to pick up the Front Attaching Support Kit (LVB25302) for our 2520. I had kept the one from our 2320 (LVB24895) but that obviously would not work. Since the support kit for the 2320 was a 1 piece design, even I could determine where and how to mount it. My question on the two brackets for the 2520 is where they go in relationship to the frame of the tractor. I can obviously match up the bolt holes but it would appear as if these brackets would fit outside the frame but inside the grille guard, thus replacing the black plastic spacers in there now.

Is that correct?


Thanks,
lost
Did the drive shaft from your 2320 fit your 2520? I bought a blower off of a 2320 and the drive shaft seems to be to long.

Thanks,
Jeremy
 

· Registered
Joined
·
64 Posts
Doug

Any chance you could measure your 2520 shaft. Overall length would be great. The 2320 shaft I have is about 70 1/8 long. I think I may just cut it down if I can find the right length to make it.

Thanks again for responding.

Jeremy
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top