Green Tractor Talk banner

2520 temp guage

3596 Views 9 Replies 4 Participants Last post by  andy b.
Finally got around to installing a temperature guage in the 2520. Not hard to do but a little time consuming. Trickiest part was figuring out the correct wiring. Turned out that I tapped into the hot wire leading to the PTO for the sending unit and used one of the wires in the light switch for the little bulb for the guage. Guage lights up whenever the rest of the guages are lit. All in all very satisfying.

In the last half hour that I worked I installed my Artillian forks. These are definitely good kit. Highly recommended. Randy........are you listening? :mocking:

Tomorrow I am putting tail lights in the X540.

Ahhhhhhh ........... Spring!!
1 - 1 of 10 Posts
Hey Ron
What kind (brand) of gauge did you use?

1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.