Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter · #1 ·
Just did 1000 hour maintenance on my 3033r - most of it anyway. One item is to check valve clearance. I've considered trying that myself. The actual checking and adjusting should be no problem at all. Getting everything off to remove the valve cover might be another issue, though. Has anyone tackled this and, if so, what would I be getting into?
 

·
Registered
Joined
·
379 Posts
I've done it on a 4200. Took a few hours because I'm slow. I had to remove a few items like the muffler and air filter to get to the valve cover. I also followed the directions in the factory service manual - I think that helped.
 
  • Like
Reactions: ridesdirt
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top