Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hi everyone, my 3320 recently started having issues with the forward motion where the machine would still go forward a bit erratically even without the pedal pressed. The err 02 is probably from me jamming the reverse pedal to stop the machine.

I have the technical manual and am fully capable of doing diagnostics. The manual talks about having the service advisor software to do the calibration. Is there a way to replace the sensor and do the calibration without special tools? Just curious what others went through before I get into it... :)
 

·
Registered
Joined
·
990 Posts
The technical manual should also give instructions on how to perform calibration using volt meter to set the potentiometer and then accessing calibration mode through the dash using the turn signal switch.
 
1 - 2 of 2 Posts
Top