Green Tractor Talk banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
3,564 Posts
Discussion Starter · #1 ·
While I was removing items and putting in a new light switch, I noticed that my 3rd SCV lever will not stay forward in the float position. I can dfeel the spot there it goes into the float position, but there is not enough tension for it to stay forward. Is there a way to adjust this?
 

·
Registered
Joined
·
733 Posts
Yep.....Lemme check my manual to be sure. I know it was clearly explained in the instructions supplied with the 3rd SCV.
I want to say its adjusted at the valve bank.
 

·
Registered
Joined
·
33 Posts
I did not realize that it was meant to stay in float. Would that adjustment hold true for my 3320 3rd SCV?
 

·
Premium Member
Joined
·
3,564 Posts
Discussion Starter · #5 ·
My 3720 open station would hold float also Dave. This lever is so smooth, it makes me wonder if the lubricated it somewhere and the detent is not strong enough to hold it with the lube...
 

·
Premium Member
Joined
·
971 Posts
On my cab 4520, if I push the 3rd SCV forward there is a detent-like stop. If you talk to the tractor real nice and then hold your breath, it stays there. Anything else and it pops out. So it's either over lubed, under springed, or needs another 1/8" of travel to get into the notch permanently.

Pete
 
1 - 7 of 7 Posts
Top