Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter #1
just curious, will the pin on forks for the 60, 70, and 70A work on the 40 loader? I know the pin diameters are the same not sure about the width. Pin spacing is 7 3/8" center to center, and center of loader cylinder to the center of the loader cylinder is 41 3/4". Obviously the lifting capacity would be limited but much better than clamp on forks where you lose alot due to the length of the bucket
 

·
GTT Vendor
Joined
·
1,534 Posts
just curious, will the pin on forks for the 60, 70, and 70A work on the 40 loader? I know the pin diameters are the same not sure about the width. Pin spacing is 7 3/8" center to center, and center of loader cylinder to the center of the loader cylinder is 41 3/4". Obviously the lifting capacity would be limited but much better than clamp on forks where you lose alot due to the length of the bucket
Hello,

We've determined that the pin on frame can be adapted to the 40 loader, but there are still a few other questions to answer. If you want to send an email, I can reply with a document to help get the needed measurements. My signature contains a link to email.

Thanks!
 
1 - 2 of 2 Posts
Top