Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
So first time I have done a steering arm replacement on my 4700. I had the old hydraulic cylinder still that can not be serviced, as I am putting new cylinder in I notice that there are no grease fittings for the ends. There are boots present on each end but no grease fittings? Is this wrong or do I have to do something to add grease fittings? The schematics don't show one but it doesn't show on the old one but it has them.
796285
Rectangle Font Parallel Slope Screenshot
 

·
Administrator
Joined
·
22,927 Posts
Sadly, JD eliminated the grease fittings on all the newer steering cylinders.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top