Green Tractor Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Have been looking far and wide and have not found a 54c belly blade to go a on my JD 317 to grade my dirt driveway. I would like one with hydraulic angle. Any leads out there, I am located in 54562 and willing to travel. The only other option I see would be to buy a sleeve hitch and a bliny rear blade which are expensive. Thanks for all your help,
 

·
Registered
Joined
·
1,827 Posts
Northwoods,

You can easily make your own belly blade from a lawn tractor snow blade as I did by cutting down the height of the moldboard. Attached are some threads from my build that I saved as PDF files. My avatar shows this blade on my 322 tractor. This picture is in the threads attached, but is representative of what was done:
Motor vehicle Table Bumper Automotive exterior Asphalt


Chuck
 

Attachments

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top