[Scoutx]

Hey all, trying to hook up a hitch kitch to the 60" HD broom for my 1025r.

I took off the old 3 series triangle hitch and am trying to put the bvl10795 on.

It looks like this:

The manual doesn't tell how to attach the hardware. I have two bolts with spacers that I believe go where the 1 arrows are pointing. When I do this it allows the brush to rotate around that collar a little bit, which I think is by design. There is however a big hold that lines up with the yellow sleeve and the black collar that I don't know what to do with.

This shows the #2 designated hole better:

Finally, I accidentally separated the driveshaft and the splines do not want to recollapse. Any tricks? is it phased? Thanks all!

 

[Scoutx]

So I figured the splines have a key, there was a lot of grease on the pto shaft.

I aslo just went with the two bolts as decribed and tried it out. It seems to do alright and now I understand a little better how it finds a level on that collar. I think I'm good, but open to advice. Thanks.

 

[ssjfyr]

Without digging mine completely out of storage, it looks to be the exact same as yours. No idea what that hole is for. Maybe if a person wanted to stop the housing from rotating for some reason they would put a bolt through there or something?

 

[Scoutx]

Without digging mine completely out of storage, it looks to be the exact same as yours. No idea what that hole is for. Maybe if a person wanted to stop the housing from rotating for some reason they would put a bolt through there or something?

Thanks, no worries. I chucked it together and tried it out, makes a lot more sense now. Thanks.