Green Tractor Talk banner
1 - 2 of 2 Posts

· Registered
Joined
·
5,114 Posts
The great looking thing about that valve is that it's small and would be great for the limited real estate that most of our tractors have.

What isn't readily apparent to me is how would you mount it (although I realize that the OP is wanting something "temporary"). Three of the four sides of the valve block have fittings on them. I would think that you would want to mount the valve so that the flat (non-fitting side) side of the of the valve to whatever surface is available on the tractor. But the mounting holes look like they run from one side to the other and not from top to bottom.

Keep in mind that I'm not a designer/fabricator and that sometimes something obvious may escape me. :) I'm sure one of you smarter-than-me guys (and there are many!) will point out how this thing should be mounted.
 
  • Like
Reactions: chex313

· Registered
Joined
·
5,114 Posts
Most of them are "weather resistant".
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top