Green Tractor Talk banner

1 - 15 of 15 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I recently put new injectors in the tractor and had the pump done up so why would it be smokey
If anyone could help I would appreciate it
Yhanks
 

·
Registered
Joined
·
918 Posts
I recently put new injectors in the tractor and had the pump done up so why would it be smokey
If anyone could help I would appreciate it
Yhanks
Was the engine smokey before the pump and injectors were done? Is it white smoke or black ?I would check to be sure pump timing was adjusted properly. If that is good, then check compression. Low compression causes white smoke ALso be sure to use fresh high quality fuel.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #4
6200

Was the engine smokey before the pump and injectors were done? Is it white smoke or black ?I would check to be sure pump timing was adjusted properly. If that is good, then check compression. Low compression causes white smoke ALso be sure to use fresh high quality fuel.
Well all I can tell you is that the pump was sent to a specialist to be done .The smoke isn't black more white

Thanks
 

·
Registered
Joined
·
8 Posts
Discussion Starter #6
Did person installing inj pump time it correctly????????????
Jim all I can do is presume that he did it's what he does for a living.The tractor doesn't seem to have a Miss or anything.Could it be something more serious
 

·
Registered
Joined
·
4,425 Posts
Did you reinstall the pump on the engine or did the shop do it?
 

·
Registered
Joined
·
1,811 Posts
If it was my tractor I'd ""make note of position of inj pump on engine block"" then loosen mounting nuts & rotate pump a degree or 2 to advance IP timing,tighten nuts then start engine to determine if smoke went away & how engine operates.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #11
I tried moving it a little both ways but didn't seem to make much difference.Still a bit smokey.What do you think now?
 

·
Registered
Joined
·
4,425 Posts
You must line up the timing marks on the drive gears. There should be one on the crankshaft and one on the pump.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #14
Jim I had a fellow call today to see it .He gave the pump a wee move and changed air filters and I'd say I've at least 10hp more.Tomorrow I'm going to check gause in the diesel tank too.He was a bit like yourself he knows his stuff.
Thank you very much for all your help it was greatly appreciated 👍
 
1 - 15 of 15 Posts
Top