Green Tractor Talk banner

1 - 4 of 4 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter #1
Does anyone have the 7 pin trailer connector (BLV11095) installed on a cab 3R with the 3rd SCV? It looks in the manual with the kit like it goes where the SCV is, blocking the installation. The kit comes with a second bracket that doesn’t seem to mount anywhere. Any thoughts or photos would be appreciated.

Thanks
 

·
Registered
Joined
·
84 Posts
IMG_0001[1].JPG IMG_0002[1].JPG

The kit comes with two brackets, one for the 4 series and one for the 3 series. There isn't enough room to either mount the bracket to the cab or if you could clear the hard lines for the 3rd SCV. I mounted the 3 series brkt to a piece of aluminum angle and the angle to the cab. I will get a better picture tomorrow in the daylight.
 

·
Registered
Joined
·
77 Posts
Discussion Starter #3
That looks good, I found everything you mentioned when trying to install it, glad to see I wasn’t just going nuts. Nice install with the angle. This kit is definitely deficient for this mounting setup.
 
1 - 4 of 4 Posts
Top