Green Tractor Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi All,
I have a new X739 and am experiencing lag/delay in the deck height hydraulic circuit. It's especially noticeable when running my aftermarket FEL and can be 1-2 seconds.
It presents in both directions and doesn't seem to have any effect on power, there's plenty, it just takes a moment to kick in. I also do not see this kind of lag in the other circuit. Additionally I would say it's the same with the deck on and off.

It doesn't seem to be an oil level issue, I've topped that off both from the showroom and after hooking up the FEL and filling the hoses/cylinders.

Any feedback is appreciated. In addition i'm wondering if there's a way to isolate the deck height from the auxiliary since you don't typically use both at the same time.

If there's a similar thread I apologize, searching and manually paging through didn't yield anything.
Thanks
Scott
 

·
Registered
Joined
·
1,314 Posts
Hi All,
I have a new X739 and am experiencing lag/delay in the deck height hydraulic circuit. It's especially noticeable when running my aftermarket FEL and can be 1-2 seconds.
It presents in both directions and doesn't seem to have any effect on power, there's plenty, it just takes a moment to kick in. I also do not see this kind of lag in the other circuit. Additionally I would say it's the same with the deck on and off.

It doesn't seem to be an oil level issue, I've topped that off both from the showroom and after hooking up the FEL and filling the hoses/cylinders.

Any feedback is appreciated. In addition i'm wondering if there's a way to isolate the deck height from the auxiliary since you don't typically use both at the same time.

If there's a similar thread I apologize, searching and manually paging through didn't yield anything.
Thanks
Scott
What do you mean by auxiliary circuit? Do you mean the three point? I believe they operate off the same rock shaft so no you can't isolate it.

I think your delay is probably normal. I seem to remember on my 425 it taking a second or two for the deck to raise or lower. With the smaller tractors they don't put the fastest/power pumps on them so....
 
1 - 3 of 3 Posts
Top