Green Tractor Talk banner

1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Hi Folks,
I just bought a 930 Moco conditioner (impeller) and I'm trying to put a new set of knives on it and have yet to break one of the bolts holding the knives on loose. I don't want to put a 1" impact on it until I learn if there's a trick to this job. I've ordered a book but haven't received it yet.
 

·
Registered
Joined
·
588 Posts
Here is what I found on YouTube. It is for an 830, hopefully the cutterbar is similar to yours. I suggest soaking the bolts down with PBlaster, a few times a day or even go out tonight and do it. Antisieze the bolts before going back in with new blades. Good Luck! :bigthumb:

https://m.youtube.com/watch?v=MM-2pDUe10k
 
1 - 2 of 2 Posts
Top